Finally found out why I wasn't able to tune the fence and miter gauge of the table saw down to the last percent of accuracy. Turns out the blade itself wasn't parallel to the miter slots, as it's supposed to be when coming from the factory.

So I RTFM and found some screws to adjust it, which I had no idea existed at all.

Follow

Definitely not a thing you hear a lot about in beginner learning material, but adjusting your machines properly seems to be quite an important skill and semi-regular task in .

@raucao

Been there, done that 😄
There are many good videos around.

If you can understand Italian, follow this woodworking channel by Stefano il Falegname:

yewtu.be/channel/UCoFKp_9wRw6F

For Californian English, instead, I suggest Steve Ramsey:

yewtu.be/channel/UCBB7sYb14uBt

For both start from the oldest videos, there are hidden gems.

Sign in to participate in the conversation
kosmos.social

kosmos.social is a friendly place for tooting, run by the Kosmos open-source co-operative.